APA102 leds not working, some questions Hardware Support Hyperion
Posted on by
Hyperion Leds Not Working Noise. The LEDs do not change color, only White. Hardware Support Hyperion The only time the LEDs light up was when I used LED controller Sk6822spi/ws2812spi with GPIO 10. After some seconds of booting the 10th LED lights up in Green Color.
LEDs not working on Archlinux x86_64 with Framebuffer Screen Capture from hyperion-project.org
In case your LED device is not working or shows as being disabled in the Dashboard or Remote Control, check Hyperion's log for errors first! This did never occur on my old setup (Libreelec, RPi 3, old Hyperion, PWM on GPIO18) so I assume my wiring to be fine
LEDs not working on Archlinux x86_64 with Framebuffer Screen Capture
I can run the setup perfectly with 15 LEDs connected to hyperion but when I change it over to 747 string the setup does not respond Should I open a separate Issue for that? SPI would be better anyway right? I hope someone can help me, getting my LEDs running again with the NG version In case your LED device is not working or shows as being disabled in the Dashboard or Remote Control, check Hyperion's log for errors first!
The LEDs do not change color, only White. Hardware Support Hyperion. There is no reason I can think of for this issue to happen Here are some common reasons your LEDs might not be working: 1.
LED's not powering on, Everything looks right. Software Support. The only time the LEDs light up was when I used LED controller Sk6822spi/ws2812spi with GPIO 10. I tried both installing Hyperion on Raspberry Pi OS, as well as running Hyperbian with the same results - no lights